Wild Ginger Software Forums
Wild Ginger Software Forums
Search Forums | Wiki | WG TV | Newsletter | Blog | Pinterest | Albums | Language
You are logged in as a guest. ( logon | register )

Showing sloper
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Wild Ginger Software - Public -> PatternMaster Pattern Editor Projects - PublicMessage format
 
magenta
Posted 2011-05-13 5:35 AM (#75235)
Subject: Showing sloper



Extreme Veteran

Posts: 386
100100100252525
Location: Canberra, Australia
Hi, Is there a way to just bring your sloper up onto PE to design something from scratch? At the moment I just choose some random design from SE and save it with the sloper. When I open it in PE, I delete the pattern pieces then go from there. Just wondered if there was another way of doing it.

Sarah
Top of the page Bottom of the page
Karen - Tech Support
Posted 2011-05-13 8:15 AM (#75236 - in reply to #75235)
Subject: RE: Showing sloper



Tech Support

50005000100010025
Location: Colorado Springs, CO
You could save the fitting gament without seam allowances.  Then just open your saved file in PE to start.
Top of the page Bottom of the page
magenta
Posted 2011-05-13 8:06 PM (#75248 - in reply to #75236)
Subject: RE: Showing sloper



Extreme Veteran

Posts: 386
100100100252525
Location: Canberra, Australia
Thanks for that Karen. Will give it a go.

Sarah
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version

(Delete all cookies set by this site)
© 1995-2018 Wild Ginger Software, Inc. All rights reserved.