Wild Ginger Software Forums
Wild Ginger Software Forums
Search Forums | Wiki | WG TV | Newsletter | Blog | Pinterest | Albums | Language
You are logged in as a guest. ( logon | register )

Tailor Made Dress Shirt - Fit Garment Sleeve Ease
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Wild Ginger Software - Public -> PatternMaster - PublicMessage format
 
strfsh
Posted 2016-01-19 2:52 AM (#90887)
Subject: Tailor Made Dress Shirt - Fit Garment Sleeve Ease


New User

Posts: 1

Hi There,

I'm new to Wild Ginger and fairly new to sewing. I have purchased Tailor Made v6, have entered my measurements and now trying to put together my men's dress shirt Fit Garment. After cutting out the pieces I walked the sleeve pattern along the front and back pattern armhole and noticed a half inch of ease. When I proceeded to sew and set the sleeve like in the instructions by matching the notches (X circle, X square, and center notch), the seam between the center notch and back X circle marking caused gathered because of the ease. Was this intended? If not how do I avoid the gathering that is happening?

Thanks!
Top of the page Bottom of the page
Karen - Tech Support
Posted 2016-01-19 7:13 AM (#90888 - in reply to #90887)
Subject: Re: Tailor Made Dress Shirt - Fit Garment Sleeve Ease



Tech Support

500050001000100
Location: Colorado Springs, CO

The square and circle only indicate front and back. They are not matched for ease. Check for ease dots on the sleeve pattern.

Checked and the fit sleeve does not have the dots.  To see how to put in this sleeve open the classic shirt with a set in sleeve and go to the sewing guide. 

Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version

(Delete all cookies set by this site)
© 1995-2018 Wild Ginger Software, Inc. All rights reserved.