Yardage calculator does not work in PMB5
Varda
Posted 2017-12-24 7:00 PM (#92405)
Subject: Yardage calculator does not work in PMB5


Member

Posts: 8

The botun is gray and when I try do it via the file menu, and the pattern is displayed, I cannot change the fabric width, it stays at 0. The default is inches.
I do not expect an answer till after xmas, have a merry one, Y'all.


Edited by Varda 2017-12-24 7:01 PM
Top of the page Bottom of the page
Karen - Tech Support
Posted 2017-12-25 12:23 AM (#92406 - in reply to #92405)
Subject: Re: Yardage calculator does not work in PMB5



Tech Support

50005000100010025
Location: Colorado Springs, CO
You select either 45 or 60. Then select flat or folded. Not sure what is gray. Default length is 72 inches.
Top of the page Bottom of the page
Varda
Posted 2017-12-26 12:28 PM (#92407 - in reply to #92406)
Subject: Re: Yardage calculator does not work in PMB5


Member

Posts: 8

Thanks, Karen. I figured it out. I had to setup layout first and it worked.
Top of the page Bottom of the page