slacks back and front fit
Varda
Posted 2017-12-07 12:19 PM (#92388)
Subject: slacks back and front fit


Member

Posts: 8

I am measured correctly , but the slack front is too high and the back is too short, by about 3/4 inch. I am Using pmb 5. can I tweek this? did not have this issue before. using the natural weist.
Top of the page Bottom of the page
sewsally
Posted 2017-12-07 12:30 PM (#92390 - in reply to #92388)
Subject: Re: slacks back and front fit



Elite Veteran

Posts: 1058
10002525
Location: North of Seattle, WA
Photos would be good.
But have you tried the Wild Cut? That would raise the back.
Also I think you can raise or lower the front and back waist in pmb 5 once you figure out what you want those settings to be.
Top of the page Bottom of the page
Varda
Posted 2017-12-07 12:33 PM (#92391 - in reply to #92390)
Subject: Re: slacks back and front fit


Member

Posts: 8

Thanks, will try the wild cut.
Top of the page Bottom of the page
Karen - Tech Support
Posted 2017-12-07 10:19 PM (#92392 - in reply to #92388)
Subject: Re: slacks back and front fit



Tech Support

50005000100010025
Location: Colorado Springs, CO
Pictures can help. Is the hip balance line you draw on the fit pants level?
Top of the page Bottom of the page
Varda
Posted 2017-12-19 12:35 PM (#92401 - in reply to #92388)
Subject: Re: slacks back and front fit


Member

Posts: 8

Well, i did lower the back, raised the front, extended the crotch back, I did check, the style and setting are saved , but when print the new pieces, it is exactly the same as as before.
Top of the page Bottom of the page
Karen - Tech Support
Posted 2017-12-20 6:56 AM (#92402 - in reply to #92388)
Subject: Re: slacks back and front fit



Tech Support

50005000100010025
Location: Colorado Springs, CO
Please send your database to support@wildginger.com It is pmbcharts.sdf Tell me the name of the saved style. Pictures of the first pants would help us help you.
Top of the page Bottom of the page